On 19.07.2010, at 11:00, Gleb Natapov wrote: On Mon, Jul 19, 2010 at 10:54:43AM +0200, Alexander Graf wrote:
On 19.07.2010, at 10:48, Gleb Natapov wrote:
Were there DMA capable devices back in ISA times? There must be. If so, we can just take a look at what they do and do it similarly. Bus mastering was a new thing for PCI, right?
I think IDE can be considered DMA capable ISA device, no? At least
it works by writing to PIO ports and getting result into memory, but
with interrupts and status bits and everything that real device should
have. On board DMA engine is also ISA device.
We could define our device to be polling. So all we need is a status bit that the guest sets when it starts the DMA and the device unsets when the DMA is done. In our case that should be immediate, because the PIO invokes the full code paths, but it would look more like a real device, no?
This is better, but it shouldn't be synchronous. Kernel and initrd are on disk so why not setup aio and read them from io thread allowing vcpu thread immediately return to guest mode to process interrupts.
That would work with the above described device model. If we're going synchronous or asynchronous would become an implementation detail. Or why
not use virtio-serial while we are at it? After all virtio-serial is
there to allow host and guest communication.
Because virtio-serial needs us to set up the full virtio-pci stack. That's too much to mess with in an option rom IMHO.
Alex
|