[Qemu-devel] [PATCH] audio: reset timer when enabling capture mode

[Michael Walle]

The audio timer also has to be reset when a capture device is enabled. This
will ensure the timer to be started even if just capture devices are
active.

Signed-off-by: Michael Walle <address@hidden>
---
 audio/audio.c |    1 +
 1 files changed, 1 insertions(+), 0 deletions(-)

diff --git a/audio/audio.c b/audio/audio.c
index ade342e..1edbb29 100644
--- a/audio/audio.c
+++ b/audio/audio.c
@@ -1240,6 +1240,7 @@ void AUD_set_active_in (SWVoiceIn *sw, int on)
                 hw->enabled = 1;
                 if (s->vm_running) {
                     hw->pcm_ops->ctl_in (hw, VOICE_ENABLE, conf.try_poll_in);
+                    audio_reset_timer ();
                 }
             }
             sw->total_hw_samples_acquired = hw->total_samples_captured;
-- 
1.7.2.3