On 29 September 2011 06:03, Peter Chubb <address@hidden> wrote:
Stefan> That's the reason why line buffering is needed today. I
Stefan> enable log file output to see what happened last before the
Stefan> crash.
Thanks for this, I didn't think of this use-case. I don't think I've
ever seen a qemu crash that wasn't caused by something really obvious.
You don't need the logging for the obvious ones :-)
abort() already flushes all open streams. So only signals that cause
immediate death are a problem: SIGSEGV is the obvious one. If its
handler called abort() then that would flush too. abort() is
guaranteed by the POSIX spec to be callable from a signal handler.
Catching SIGSEGV is likely to interact badly with the signal
handling in linux-user mode, I expect.
Stefan> Speed is not the primary target when somebody runs qemu -d ...
It is if it takes hours to reach the problem that causes
the abort(). Speeding up by an order of magnitude is worth it.
One tactic I've found useful in these cases is to run without
logging up to nearly the point where things fail, and then
do a savevm. Then you can loadvm on a qemu with logging enabled
and only look at the section of execution that causes the problem.