[Qemu-devel] [PATCH 1.2 1/7] block: flush in writethrough mode after writes

[Paolo Bonzini]

We want to make the formats handle their own flushes
autonomously, while keeping for guests the ability to use a writethrough
cache.  Since formats will write metadata via bs->file, bdrv_co_do_writev
is the only place where we need to add a flush.

Signed-off-by: Paolo Bonzini <address@hidden>
---
 block.c |   11 +++++++++--
 1 files changed, 9 insertions(+), 2 deletions(-)

diff --git a/block.c b/block.c
index af2ab4f..7add33c 100644
--- a/block.c
+++ b/block.c
@@ -1747,8 +1747,8 @@ int bdrv_pwrite_sync(BlockDriverState *bs, int64_t offset,
         return ret;
     }
 
-    /* No flush needed for cache modes that use O_DSYNC */
-    if ((bs->open_flags & BDRV_O_CACHE_WB) != 0) {
+    /* No flush needed for cache modes that already do it */
+    if (bs->enable_write_cache) {
         bdrv_flush(bs);
     }
 
@@ -1797,6 +1797,9 @@ static int coroutine_fn 
bdrv_co_do_copy_on_readv(BlockDriverState *bs,
         ret = bdrv_co_do_write_zeroes(bs, cluster_sector_num,
                                       cluster_nb_sectors);
     } else {
+        /* This does not change the data on the disk, it is not necessary
+         * to flush even in cache=writethrough mode.
+         */
         ret = drv->bdrv_co_writev(bs, cluster_sector_num, cluster_nb_sectors,
                                   &bounce_qiov);
     }
@@ -1966,6 +1969,10 @@ static int coroutine_fn 
bdrv_co_do_writev(BlockDriverState *bs,
         ret = drv->bdrv_co_writev(bs, sector_num, nb_sectors, qiov);
     }
 
+    if (ret == 0 && !bs->enable_write_cache) {
+        ret = bdrv_co_flush(bs);
+    }
+
     if (bs->dirty_bitmap) {
         set_dirty_bitmap(bs, sector_num, nb_sectors, 1);
     }
-- 
1.7.1