[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Qemu-devel] [PATCH v6 0/4] KVM flash memory support
From: |
Jordan Justen |
Subject: |
[Qemu-devel] [PATCH v6 0/4] KVM flash memory support |
Date: |
Wed, 15 May 2013 01:02:14 -0700 |
git://github.com/jljusten/qemu.git kvm-flash-v6
Utilize KVM_CAP_READONLY_MEM to support PC system flash emulation
with KVM.
v6:
* Rebase to master following 9e1c2ec8
* Make sure patch 1 "isapc: Fix non-KVM qemu boot" can be
applied individually. (It is a candidate for 1.5.)
v5:
* Remove patch to pflash_cfi01 which enabled readonly mode
* Adjust kvm code to use KVM READONLY support for ranges that
either have the readonly flag set, or for devices with
readable set.
v4:
* With a machine type of isapc, don't mark the BIOS as read-only.
isapc + seabios will not boot if the BIOS is read-only. This
matches the current behavior of isapc with KVM, which is the
only mode under which isapc currently works.
v3:
* Squash patch 2 & 3 based on Xiao's feedback that what I
was calling a 'workaround' in patch 3 was actually what
is required by the KVM READONLY memory support.
v2:
* Remove rom_only from PC_COMPAT_1_4
* Only enable flash when a pflash drive is created.
Jordan Justen (4):
isapc: Fix non-KVM qemu boot (read/write memory for isapc BIOS)
kvm: add kvm_readonly_mem_enabled
kvm: support using KVM_MEM_READONLY flag for regions
pc_sysfw: allow flash (-pflash) memory to be used with KVM
hw/block/pc_sysfw.c | 62 ++++++++++++++++++++++++++++++++------------------
hw/i386/pc_piix.c | 5 ++++
include/sysemu/kvm.h | 10 ++++++++
kvm-all.c | 44 +++++++++++++++++++++++++++--------
kvm-stub.c | 1 +
5 files changed, 91 insertions(+), 31 deletions(-)
--
1.7.10.4
- [Qemu-devel] [PATCH v6 0/4] KVM flash memory support,
Jordan Justen <=