Re: [Qemu-devel] [PATCH] target-moxie: Add moxie Marin SoC support

[Peter Crosthwaite]

On Mon, Dec 16, 2013 at 7:02 AM, Anthony Green <address@hidden> wrote:
> Andreas Färber <address@hidden> writes:
>
>>> The Marin SoC currently runs on two boards: the Nexys3 (Xilinx) and DE-2
>>> (Altera).  They are pretty much identical from the software side of
>>> things.

Ok but do they have the same peripheral set? We had this discussion
with Allwinner where it was decided that even though the initial
peripheral set was generic enough for software to boot, going forward
it would not be true to the actual hardware. Sooner or later as you
add peripherals the difference between Altera and Xilinx board
definitions will stop your all-in-one approach wont it?

>>>  Marin currently provides the UART, PIC, 7 segment display and
>>> timer devices, as well as various memory controllers.  There's no useful
>>> distinction between SoC and board at this time.

I see the definition of Marin as a proper QEMU SoC quite useful here.
Marin is then instantiated on Nexys3 or DE2 on the board level.

Ideally we have a nexys3 or DE2 board definition that can instantiate
a number of soft SoCs (e.g. swap out Microblaze or Marin even), but
i'd leave that as follow up as its kind of hard to pull off.

 I'd like to keep it
>>> simple as per my patch rather than try to factor them out prematurely.
>>
>> I thought I've seen a number of odd embedded systems already, but I'm
>> having trouble understanding your combination of SoC and FPGA: Xilinx
>> and Altera both have SoCs combining a Cortex-A9 with an FPGA. But your
>> reference to Xilinx and Altera boards rather sounds as if Moxie is used
>> as a soft-core processor on the FPGA? In that case the term "SoC" would
>> be really confusing to me... Can you clarify or aid with some links?

So we need to clarify terminology. SoC and FPGA are not mutually
exclusive, and not just talking about Zynq and Altera hard ARM
FPGA+SoC. If you just have a raw FPGA and configure it with a
processor and peripherals then isn't that now a SoC in its own right?

I have seen the SoC term used for years when referring to soft
Microblaze systems so I think Anthonys terminology is good. You don't
need hard silicon to be a SoC.

Google this (exluding Zynq from the search helps a lot):

microblaze SoC -zynq

>
> Moxie is an architecture.  MoxieLite is one implementation of that
> architecture (non-pipelined, resource-light).  Marin is a kind of SoC -
> the combination of the MoxieLite core along with various peripherals and
> controllers.
>
> http://github.com/atgreen/moxie-cores
>

So you just synthesize this Verilog into a FPGA bistream right?

Have a Nexys bitstream and linux boot instructions handy?

> It is similar, in a way, to the Miklymist SoC, which uses an LM32
> soft-core (and is supported by qemu).
>

And the PetaLogix+Microblaze stuff.

> The Xilinx and Altera parts with Cortex-A9 cores are similar, except
> that that Cortex-A9 is an on-chip ASIC, instead of a soft SoC.
>

I don't see the need for QEMU to make this hard/soft distinction. It
shouldn't have to worry too much about underlying silicon
implementation.

Regards,
Peter

> AG
>