[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Qemu-devel] [PATCH] i8259: don't abort when trying to use level sen
From: |
Michael S. Tsirkin |
Subject: |
Re: [Qemu-devel] [PATCH] i8259: don't abort when trying to use level sensitive irqs |
Date: |
Mon, 5 May 2014 23:04:52 +0300 |
On Mon, May 05, 2014 at 10:02:55PM +0200, Hervé Poussineau wrote:
> Le lun. 05 mai 2014 10:01:10 CEST, Michael S. Tsirkin a écrit :
> >On Sat, May 03, 2014 at 10:39:37PM +0200, Hervé Poussineau wrote:
> >>Ping.
> >>
> >>Le 22/04/2014 23:00, Hervé Poussineau a écrit :
> >>>This is a guest-triggerable error, as seen when using Xenix 2.3.4.
> >>>Replace hw_error by LOG_UNIMPL, so that guests have at least a chance to
> >>>continue.
> >>>
> >>>Signed-off-by: Hervé Poussineau <address@hidden>
> >
> >Is it just "a chance" or does Xenix actually work well with this
> >applied?
>
> Yes,
> With this patch, I can install and use Xenix 2.3.4a without any problem.
> I can also start installation of Xenix 2.3.4q, but it fails due to
> not finding an hard disk.
>
> Regards,
>
> Hervé
Thanks!
I'll pick this patch up when I'm back online.
> >
> >
> >>>---
> >>> hw/intc/i8259.c | 3 ++-
> >>> 1 file changed, 2 insertions(+), 1 deletion(-)
> >>>
> >>>diff --git a/hw/intc/i8259.c b/hw/intc/i8259.c
> >>>index c6f248b..a069d04 100644
> >>>--- a/hw/intc/i8259.c
> >>>+++ b/hw/intc/i8259.c
> >>>@@ -265,7 +265,8 @@ static void pic_ioport_write(void *opaque, hwaddr
> >>>addr64,
> >>> s->init4 = val & 1;
> >>> s->single_mode = val & 2;
> >>> if (val & 0x08) {
> >>>- hw_error("level sensitive irq not supported");
> >>>+ qemu_log_mask(LOG_UNIMP,
> >>>+ "i8259: level sensitive irq not
> >>>supported\n");
> >>> }
> >>> } else if (val & 0x08) {
> >>> if (val & 0x04) {
> >>>
> >
>