[Qemu-devel] Missing Diag/Debug Registers in lsi53c895a emulation

[Peter Lieven]

Hi,

while trying to run an ASA1000V appliance I found that registers 0x09 and 
0x3c-3f are read during boot up. Which
currently results in an exit(1). The appliance uses an quite ancient 2.6.29.6 
Linux kernel.
These registers are mainly for diag and debug purposes so I came up with the 
following patch. The system works
with the following patch, but I wonder if this is a correct workaround:

diff --git a/hw/scsi/lsi53c895a.c b/hw/scsi/lsi53c895a.c
index ec92048..bce1135 100644
--- a/hw/scsi/lsi53c895a.c
+++ b/hw/scsi/lsi53c895a.c
@@ -1513,6 +1513,8 @@ static uint8_t lsi_reg_readb(LSIState *s, int offset)
         return 0x7f;
     case 0x08: /* Revision ID */
         return 0x00;
+    case 0x09: /* SOCL */
+        return 0x00;
     case 0xa: /* SSID */
         return s->ssid;
     case 0xb: /* SBCL */
@@ -1577,6 +1579,11 @@ static uint8_t lsi_reg_readb(LSIState *s, int offset)
         return s->sbr;
     case 0x3b: /* DCNTL */
         return s->dcntl;
+    case 0x3c: /* ADDER Output (Debug purpose only) */
+    case 0x3d:
+    case 0x3e:
+    case 0x3f:
+        return 0x00;
     case 0x40: /* SIEN0 */
         return s->sien0;
     case 0x41: /* SIEN1 */

Peter