Re: [Qemu-devel] [PATCH v2 4/4] hw/pci-bridge: push down PXB in qtree in order to format PXB bus numer

[Marcel Apfelbaum]

On 06/11/2015 12:29 AM, Laszlo Ersek wrote:
> On 06/10/15 22:11, Laszlo Ersek wrote:
> > On 06/10/15 21:34, Laszlo Ersek wrote:
> > > On 06/10/15 21:26, Marcel Apfelbaum wrote:
>
> > > > BTW, did you try to boot from it :) ?
> > >
> > > No, not yet; I'll have to write additional OVMF code for that; but the
> > > syntax is OK, and the information is there, so I'm fairly sure I can
> > > write that code. :)
> >
> > On a second thought -- I *will* write the OVMF code for this now, or
> > tomorrow, because the syntax is *still* a little bit off. I think we'll
> > need:
> >
> >    /address@hidden/address@hidden/address@hidden/address@hidden/address@hidden
> >                    ^^
> >
> > The part I marked (ie. the @ and the UnitAddress after it) are
> > mandatory. I'll just hardcode the "@0" string there in QEMU, as written
> > above.
>
> Yes, that works; I can PXE-boot with OVMF from a virtio-net-pci NIC that
> is located at the above OFW devpath.
Good!
I'll work now on Seabios
.

Thanks,
Marcel
> Thanks
> Laszlo