Re: [Qemu-devel] [PATCH 0/4] hw/net: fix m68/ColdFire ethernet fec support

[Greg Ungerer]

Hi Stefan,

On 26/06/15 20:12, Stefan Hajnoczi wrote:
> On Fri, Jun 26, 2015 at 03:27:12PM +1000, address@hidden wrote:
>>
>> The following set of patches fixes the emulated ColdFire ethernet fec
>> driver. There is primarily two problems that need to be fixed.
>>
>> 1. The emulated driver needs to support probing of an attached phy.
>>    It is strait forward to emulate an attached phy, but to avoid using
>>    magic numbers I have factored out the common MII register and value
>>    definitions into their own mii.h file first.
>>
>> 2. Fix the fec driver receiver to return the correct value.
>>
>> With these changes in place the qemu m5208evb board emulation can probe,
>> identify and use the fec ethernet running a Linux guest.
>>
>>
>>  hw/net/mcf_fec.c                |   54 ++++++++++++++++++++++++++--
>>  include/hw/net/allwinner_emac.h |   40 ---------------------
>>  include/hw/net/mii.h            |   76 
>> ++++++++++++++++++++++++++++++++++++++++
>>  3 files changed, 128 insertions(+), 42 deletions(-)
> 
> Reviewed-by: Stefan Hajnoczi <address@hidden>
> 
> If this series has no maintainer to go through I'll merge it via my net
> tree.  Please let me know if you'd like that.
> 
> mcf_fec is not fully correct yet, it needs to call
> qemu_flush_queued_packets() when rx_enabled transitions from 0 to 1.
> This will restart rx by sending any queued packets from the net
> subsystem.
> 
> In order to get flow control between NetClientState peers working the
> following is missing:
> 
> 1. mcf_fec_receive()'s !s->rx_enabled case should return -1 to drop
>    unexpected packets.
> 
> 2. mcf_fec_receive() should return 0 in the (bd.flags & FEC_BD_E) == 0
>    case where we've run out of rx buffers.  That way the net subsystem
>    queues the packet and waits until the next RDAR write transitions
>    rx_enabled from 0 to 1.

Is the correct behavior in this case to check if we can write
out the whole packet data, or too partially write out what we can?

For example it is possible that we hit bd.flags & FEC_BD_E) == 0
having written some of the packet data but now we cannot fit the rest.
So is it correct to simply return what count we have written or
should we not write unless we can fit the whole packet and return 0.

Regards
Greg