[Qemu-devel] [RFC v5 5/6] configure: Use slow-path for atomic only when the softmmu is enabled

[Alvise Rigo]

Use the new slow path for atomic instruction translation when the
softmmu is enabled.

Suggested-by: Jani Kokkonen <address@hidden>
Suggested-by: Claudio Fontana <address@hidden>
Signed-off-by: Alvise Rigo <address@hidden>
---
 configure | 11 +++++++++++
 1 file changed, 11 insertions(+)

diff --git a/configure b/configure
index cd219d8..5f72977 100755
--- a/configure
+++ b/configure
@@ -1391,6 +1391,13 @@ if test "$ARCH" = "unknown"; then
     fi
 fi
 
+# Use the slow-path for atomic instructions if the softmmu is enabled
+if test "$softmmu" = "yes"; then
+    tcg_use_ldst_excl="yes"
+else
+    tcg_use_ldst_excl="no"
+fi
+
 # Consult white-list to determine whether to enable werror
 # by default.  Only enable by default for git builds
 z_version=`cut -f3 -d. $source_path/VERSION`
@@ -4542,6 +4549,7 @@ echo "Install blobs     $blobs"
 echo "KVM support       $kvm"
 echo "RDMA support      $rdma"
 echo "TCG interpreter   $tcg_interpreter"
+echo "use ld/st excl    $tcg_use_ldst_excl"
 echo "fdt support       $fdt"
 echo "preadv support    $preadv"
 echo "fdatasync         $fdatasync"
@@ -4920,6 +4928,9 @@ fi
 if test "$tcg_interpreter" = "yes" ; then
   echo "CONFIG_TCG_INTERPRETER=y" >> $config_host_mak
 fi
+if test "$tcg_use_ldst_excl" = "yes" ; then
+  echo "CONFIG_TCG_USE_LDST_EXCL=y" >> $config_host_mak
+fi
 if test "$fdatasync" = "yes" ; then
   echo "CONFIG_FDATASYNC=y" >> $config_host_mak
 fi
-- 
2.5.3