[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Qemu-devel] [RFC 0/3] ARM: Machine specific boot blobs
From: |
Peter Crosthwaite |
Subject: |
[Qemu-devel] [RFC 0/3] ARM: Machine specific boot blobs |
Date: |
Fri, 9 Oct 2015 20:13:24 -0700 |
Hi,
This adds support for machine specific primary boot blobs. This can be
used to install little bits of firmware or boot code without having
to throw the whole QEMU bootloader out and BYO (with device drivers
and all).
It is then used to fix two boards, Zynq and Highbank, both which have
small but critical expectations of pre-boot software setup.
Regards,
Peter
Peter Crosthwaite (3):
arm: boot: Add board specific setup code API
arm: highbank: Implement dummy monitor
arm: xilinx_zynq: Add linux pre-boot
hw/arm/boot.c | 11 +++++++++++
hw/arm/highbank.c | 56 +++++++++++++++++++++++++++++++++++++++++-----------
hw/arm/xilinx_zynq.c | 41 +++++++++++++++++++++++++++++++++++++-
include/hw/arm/arm.h | 7 +++++++
4 files changed, 103 insertions(+), 12 deletions(-)
--
1.9.1
- [Qemu-devel] [RFC 0/3] ARM: Machine specific boot blobs,
Peter Crosthwaite <=