Re: [Qemu-devel] [PATCH for-2.5 v5 1/1] hw/misc: Add support for ADC controller in Xilinx Zynq 7000

[Guenter Roeck]

On Thu, Nov 12, 2015 at 09:54:55AM -0800, Peter Crosthwaite wrote:
> From: Guenter Roeck <address@hidden>
> 
> Add support for the Xilinx XADC core used in Zynq 7000.
> 
> References:
> - Zynq-7000 All Programmable SoC Technical Reference Manual
> - 7 Series FPGAs and Zynq-7000 All Programmable SoC XADC
>   Dual 12-Bit 1 MSPS Analog-to-Digital Converter
> 
> Tested with Linux using QEMU machine xilinx-zynq-a9 with devicetree
> files zynq-zc702.dtb and zynq-zc706.dtb, and kernel configuration
> multi_v7_defconfig.
> 
> Reviewed-by: Alistair Francis <address@hidden>
> Signed-off-by: Guenter Roeck <address@hidden>
> [ PC changes:
>   * Changed macro names to match TRM where possible
>   * Made programmers model macro scheme consistent
>   * Dropped XADC_ZYNQ_ prefix on local macros
>   * Fix ALM field width
>   * Update threshold-comparison interrupts in _update_ints()
>   * factored out DFIFO pushes into helper. Renamed to "push/pop"
>   * Changed xadc_reg to 10 bits and added OOB check.
>   * Reduced scope of MCTL reset to just stop channel coms.
>   * Added dummy read data to write commands
>   * Changed _ to - seperators in string names and filenames
>   * Dropped ------------ in header comment
>   * Catchall'ed _update_ints() in _write handler.
>   * Minor whitespace changes.
>   * Use ZYNQ_XADC_FIFO_DEPTH instead of ARRAY_SIZE()
> ]
> Signed-off-by: Peter Crosthwaite <address@hidden>

For v5 (same configuration as above):

Tested-by: Guenter Roeck <address@hidden>