Re: [Qemu-devel] [PATCH v2 06/11] nvdimm acpi: initialize the resource used by NVDIMM ACPI

[Dan Williams]

On Fri, Feb 19, 2016 at 12:08 AM, Michael S. Tsirkin <address@hidden> wrote:
> On Thu, Feb 18, 2016 at 11:05:23AM +0100, Igor Mammedov wrote:
>> On Thu, 18 Feb 2016 12:03:36 +0800
>> Xiao Guangrong <address@hidden> wrote:
>>
>> > On 02/18/2016 01:26 AM, Michael S. Tsirkin wrote:
>> > > On Wed, Feb 17, 2016 at 10:04:18AM +0800, Xiao Guangrong wrote:
>> > >>>>> As for the rest could that commands go via MMIO that we usually
>> > >>>>> use for control path?
>> > >>>>
>> > >>>> So both input data and output data go through single MMIO, we need to
>> > >>>> introduce a protocol to pass these data, that is complex?
>> > >>>>
>> > >>>> And is any MMIO we can reuse (more complexer？) or we should allocate 
>> > >>>> this
>> > >>>> MMIO page （the old question - where to allocated?）?
>> > >>> Maybe you could reuse/extend memhotplug IO interface,
>> > >>> or alternatively as Michael suggested add a vendor specific PCI_Config,
>> > >>> I'd suggest PM device for that (hw/acpi/[piix4.c|ihc9.c])
>> > >>> which I like even better since you won't need to care about which ports
>> > >>> to allocate at all.
>> > >>
>> > >> Well, if Michael does not object, i will do it in the next version. :)
>> > >
>> > > Sorry, the thread's so long by now that I'm no longer sure what does 
>> > > "it" refer to.
>> >
>> > Never mind i saw you were busy on other loops.
>> >
>> > "It" means the suggestion of Igor that "map each label area right after 
>> > each
>> > NVDIMM's data memory"
>> Michael pointed out that putting label right after each NVDIMM
>> might burn up to 256GB of address space due to DIMM's alignment for 256 
>> NVDIMMs.
>> However if address for each label is picked with pc_dimm_get_free_addr()
>> and label's MemoryRegion alignment is default 2MB then all labels
>> would be allocated close to each other within a single 1GB range.
>>
>> That would burn only 1GB for 500 labels which is more than possible 256 
>> NVDIMMs.
>
> I thought about it, once we support hotplug, this means that one will
> have to pre-declare how much is needed so QEMU can mark the correct
> memory reserved, that would be nasty. Maybe we always pre-reserve 1Gbyte.
> Okay but next time we need something, do we steal another Gigabyte?
> It seems too much, I'll think it over on the weekend.
>
> Really, most other devices manage to get by with 4K chunks just fine, I
> don't see why do we are so special and need to steal gigabytes of
> physically contigious phy ranges.

What's the driving use case for labels in the guest?  For example,
NVDIMM-N devices are supported by the kernel without labels.

I certainly would not want to sacrifice 1GB alignment for a label area.