[Qemu-devel] [PULL 02/15] i8257: fix Terminal Count status

[Paolo Bonzini]

From: Hervé Poussineau <address@hidden>

When a DMA transfer is done (ie all bytes have been transfered), the 
corresponding
Terminal Count bit must be set in the status register.
This bit is already cleared in i8257_read_cont and i8257_write_cont when 
required.

This fixes (at least) floppy transfer in IBM 40p firmware, which checks in DMA
controller if everything went fine.

Signed-off-by: Hervé Poussineau <address@hidden>
Message-Id: <address@hidden>
Reviewed-by: John Snow <address@hidden>
Signed-off-by: Paolo Bonzini <address@hidden>
---
 hw/dma/i8257.c | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/hw/dma/i8257.c b/hw/dma/i8257.c
index 5a52707..6078893 100644
--- a/hw/dma/i8257.c
+++ b/hw/dma/i8257.c
@@ -342,6 +342,10 @@ static void i8257_channel_run(I8257State *d, int ichan)
                              r->now[COUNT], (r->base[COUNT] + 1) << ncont);
     r->now[COUNT] = n;
     ldebug ("dma_pos %d size %d\n", n, (r->base[COUNT] + 1) << ncont);
+    if (n == (r->base[COUNT] + 1) << ncont) {
+        ldebug("transfer done\n");
+        d->status |= (1 << ichan);
+    }
 }
 
 static void i8257_dma_run(void *opaque)
-- 
2.5.0