qemu-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Qemu-devel] [PATCH v5 00/11] Support for N25Q256/512 and AT25128/256


From: marcin . krzeminski
Subject: [Qemu-devel] [PATCH v5 00/11] Support for N25Q256/512 and AT25128/256
Date: Sun, 20 Mar 2016 19:28:02 +0100

From: Marcin Krzeminski <address@hidden>

V5: Changes after review
- Macrofication of registers values
- Numonyx is default value in switch for fast read family
V4:
- Fixed RNVCR command (needed bytes set to 2 instead of 1)
- Config registers are configured only for micron flash devices
- Move config registers initialization to reset_memory function
- Removed clearing reset_enable flag when chip was selcted by CS signal
V3:
- Checkpatch run on patches
- Renamed function
V2:
- Removed support for mx66u51235 and s25fl512s from this series
- Corrected/implemented dummy cycles
- rebased to master

Marcin Krzeminski (11):
  block: m25p80: Removed unused variable
  block: m25p80: RESET_ENABLE and RESET_MEMORY commands
  block: m25p80: Widen flags variable
  block: m25p80: Extend address mode
  block: m25p80: 4byte address mode
  block: m25p80: Add configuration registers
  block: m25p80: Dummy cycles for N25Q256/512
  block: m25p80: Fast read and 4bytes commands
  block: m25p80: Implemented FSR register
  block: m25p80: n25q256a/n25q512a models
  block: m25p80: at25128a/at25256a models

 hw/block/m25p80.c | 330 ++++++++++++++++++++++++++++++++++++++++++++++++++----
 1 file changed, 311 insertions(+), 19 deletions(-)

-- 
2.5.0




reply via email to

[Prev in Thread] Current Thread [Next in Thread]