[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Qemu-devel] [PATCH v7 0/6] Add i.MX6 (Single/Dual/Quad) support
From: |
Peter Maydell |
Subject: |
Re: [Qemu-devel] [PATCH v7 0/6] Add i.MX6 (Single/Dual/Quad) support |
Date: |
Thu, 5 May 2016 15:04:50 +0100 |
On 2 April 2016 at 15:29, Jean-Christophe Dubois <address@hidden> wrote:
> This patch series adds support for the Freescale i.MX6 processor.
>
> For now we only support the following devices:
> * up to 4 Cortex A9 cores
> * A9 MPCORE (SCU, GIC, TWD)
> * 5 i.MX UARTs
> * 2 EPIT timers
> * 1 GPT timer
> * 7 GPIO controllers
> * 6 SDHC controllers
> * 5 SPI controllers
> * 1 CCM device
> * 1 SRC device
> * 3 I2C devices
> * various ROM/RAM areas.
>
> This also adds the sabrelite board as a an actual platform for i.MX6.
>
> This series was tested by booting a 4.4 linux kernel (using the
> imx_v6_v7_defconfig file as kernel configuration).
>
> Note1: as sabrelite uses uart2 as console, you have to redirect the second
> QEMU serial port to stdout.
> qemu-system-arm -M sabrelite -display none ... -serial null -serial stdio
>
> Note2: You need to disable the GPIO section related to physical push buttons
> in the Linux DTS tree in order to avoid excecive interrupt triggering on
> GPIO devices for non existant buttons.
Applied to target-arm.next, thanks.
-- PMM
[Prev in Thread] |
Current Thread |
[Next in Thread] |
- Re: [Qemu-devel] [PATCH v7 0/6] Add i.MX6 (Single/Dual/Quad) support,
Peter Maydell <=