[Qemu-devel] [PULL 14/31] scsi: megasas: check 'read_queue_head' index value

[Paolo Bonzini]

From: Prasad J Pandit <address@hidden>

While doing MegaRAID SAS controller command frame lookup, routine
'megasas_lookup_frame' uses 'read_queue_head' value as an index
into 'frames[MEGASAS_MAX_FRAMES=2048]' array. Limit its value
within array bounds to avoid any OOB access.

Reported-by: Li Qiang <address@hidden>
Signed-off-by: Prasad J Pandit <address@hidden>
Message-Id: <address@hidden>
Reviewed-by: Alexander Graf <address@hidden>
Signed-off-by: Paolo Bonzini <address@hidden>
---
 hw/scsi/megasas.c | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/hw/scsi/megasas.c b/hw/scsi/megasas.c
index bf642d4..cc66d36 100644
--- a/hw/scsi/megasas.c
+++ b/hw/scsi/megasas.c
@@ -650,7 +650,9 @@ static int megasas_init_firmware(MegasasState *s, 
MegasasCmd *cmd)
     pa_hi = le32_to_cpu(initq->pi_addr_hi);
     s->producer_pa = ((uint64_t) pa_hi << 32) | pa_lo;
     s->reply_queue_head = ldl_le_pci_dma(pcid, s->producer_pa);
+    s->reply_queue_head %= MEGASAS_MAX_FRAMES;
     s->reply_queue_tail = ldl_le_pci_dma(pcid, s->consumer_pa);
+    s->reply_queue_tail %= MEGASAS_MAX_FRAMES;
     flags = le32_to_cpu(initq->flags);
     if (flags & MFI_QUEUE_FLAG_CONTEXT64) {
         s->flags |= MEGASAS_MASK_USE_QUEUE64;
-- 
2.5.5