[Qemu-devel] [Bug 1404610] Re: [feature request] HP300 m68k system?

[Laurent Vivier]

I have Quadra 800 system emulation in the branch q800-v2.4.0.

You can create a bootable disk image following this wiki:

https://github.com/vivier/qemu-m68k/wiki

But this is not fully functional: fork() doesn't work well...

You can also find a working image from:

http://landley.net/aboriginal/

This image works better as it is based on busybox and uClibc
(the fork() bug is triggered by the lazy symbol resolution mode of glibc)

-- 
You received this bug notification because you are a member of qemu-
devel-ml, which is subscribed to QEMU.
https://bugs.launchpad.net/bugs/1404610

Title:
  [feature request] HP300 m68k system?

Status in QEMU:
  Opinion

Bug description:
  QEMU seems to support nothing (specific) that 4.4BSD was targeted
  to...would be useful to have a complete emulator for a full HP300 to
  run the binary dist from McKusick's CD set.

  Devices that'd be needed: 
  * 68020, 68030, or 68040 (How much of these are already present? Not sure if 
there was a non-standard MMU/FPU...but there was definitely a slightly-uncommon 
bus used for some peripherals)
  * Networking was lance I am pretty sure...at least the onboard one.
  * SCSI (Probably a standard chip as used EVERYWHERE ELSE..not sure off hand)
  * Framebuffers optional, serial is sufficient for basic booting of 4.4.

  Tape/disk can also be done via HP-IB...but SCSI would probably be
  easier unless extra peripherals were required (some serial stuff.)

To manage notifications about this bug go to:
https://bugs.launchpad.net/qemu/+bug/1404610/+subscriptions