[Qemu-devel] [PULL 26/30] scsi: esp: check buffer length before reading scsi command

[Paolo Bonzini]

From: Prasad J Pandit <address@hidden>

The 53C9X Fast SCSI Controller(FSC) comes with an internal 16-byte
FIFO buffer. It is used to handle command and data transfer.
Routine get_cmd() in non-DMA mode, uses 'ti_size' to read scsi
command into a buffer. Add check to validate command length against
buffer size to avoid any overrun.

Reported-by: Li Qiang <address@hidden>
Signed-off-by: Prasad J Pandit <address@hidden>
Message-Id: <address@hidden>
Signed-off-by: Paolo Bonzini <address@hidden>
---
 hw/scsi/esp.c | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/hw/scsi/esp.c b/hw/scsi/esp.c
index 3adb685..4b94bbc 100644
--- a/hw/scsi/esp.c
+++ b/hw/scsi/esp.c
@@ -98,6 +98,9 @@ static uint32_t get_cmd(ESPState *s, uint8_t *buf, uint8_t 
buflen)
         s->dma_memory_read(s->dma_opaque, buf, dmalen);
     } else {
         dmalen = s->ti_size;
+        if (dmalen > TI_BUFSZ) {
+            return 0;
+        }
         memcpy(buf, s->ti_buf, dmalen);
         buf[0] = buf[2] >> 5;
     }
-- 
2.5.5