Re: [Qemu-devel] Virtio-net cli parameters

[Pradeep Kiruvale]

On 14 October 2016 at 15:26, Stefan Hajnoczi <address@hidden> wrote:

> On Mon, Oct 10, 2016 at 03:00:20PM +0200, Pradeep Kiruvale wrote:
> > On 10 October 2016 at 11:26, Pradeep Kiruvale <address@hidden
> >
> > wrote:
> >
> > > Hi Stefan,
> > >
> > > Thanks for the reply.
> > >
> > > On 30 September 2016 at 15:49, Stefan Hajnoczi <address@hidden>
> wrote:
> > >
> > >> On Thu, Sep 29, 2016 at 04:11:27PM +0200, Pradeep Kiruvale wrote:
> > >> > Hi Stefan,
> > >> >
> > >> > On 28 September 2016 at 10:29, Stefan Hajnoczi <address@hidden>
> > >> wrote:
> > >> >
> > >> > > On Mon, Sep 26, 2016 at 05:41:55PM +0200, Pradeep Kiruvale wrote:
> > >> > > > I want to add couple of new cli options for the virtio-net
> driver
> > >> and use
> > >> > > > them inside the
> > >> > > > virtio-net driver to throttle the packets. I did go through the
> > >> code and
> > >> > > > did single stepping
> > >> > > > using the gdb, but still could not find the place where the
> > >> virtio-net
> > >> > > > parameters are getting
> > >> > > > parsed and populated into the virtio-net structures.
> > >> > > > Could some one please guide/suggest where to look into, in qemu
> code
> > >> > > base?
> > >> > >
> > >> > > Take a look at virtio_net_properties[] in hw/net/virtio-net.c.
> > >> > >
> > >> >
> > >> > These variables/properties are static variables. What I am looking
> > >> about is
> > >> > how can I pass a cli option from qemu into virtio-net driver.
> > >>
> > >> When you say "virtio-net driver" I think you mean the virtio-net
> > >> device emulation code in QEMU?
> > >>
> > > Yes, which the virtio-net driver uses to do the network I/O.
> > >
> > >>
> > >> These *are* the properties that can be set from the QEMU command-line.
> > >> For example:
> > >>
> > >>   -device virtio-net-pci,csum=off
> > >>
> > > This is the clue, I was looking for. I will see how to proceed from
> here
> > > on.
> > >
> > But when I have a cli option like below, how can pass above options?
> > -net nic,macaddr=52:54:00:37:4d:10,model=virtio
>
> Please look at "Network Devices" in docs/qdev-device-use.txt for
> information on modern -netdev/-device syntax.
>
> The old -net syntax should be replaced with the more powerful
> -netdev/-device syntax.
>
> Thanks Stefan for suggestions. I will have a look.

Regards,
Pradeep

Stefan
>