Re: [Qemu-devel] [Qemu-stable] [PATCH 2/2] block: Pass unaligned discard requests to drivers

[Peter Lieven]

Am 11.11.2016 um 00:10 schrieb Eric Blake:
> Discard is advisory, so rounding the requests to alignment
> boundaries is never semantically wrong from the data that
> the guest sees.  But at least the Dell Equallogic iSCSI SANs
> has an interesting property that its advertised discard
> alignment is 15M, yet documents that discarding a sequence
> of 1M slices will eventually result in the 15M page being
> marked as discarded, and it is possible to observe which
> pages have been discarded.
>
> Between commits 9f1963b and b8d0a980, we converted the block
> layer to a byte-based interface that ultimately ignores any
> unaligned head or tail based on the driver's advertised
> discard granularity, which means that qemu 2.7 refuses to
> pass any discard request smaller than 15M down to the Dell
> Equallogic hardware.  This is a slight regression in behavior
> compared to earlier qemu, where a guest executing discards
> in power-of-2 chunks used to be able to get every page
> discarded, but is now left with various pages still allocated
> because the guest requests did not align with the hardware's
> 15M pages.
>
> Since the SCSI specification says nothing about a minimum
> discard granularity, and only documents the preferred
> alignment, it is best if the block layer gives the driver
> every bit of information about discard requests, rather than
> rounding it to alignment boundaries early.
>
> Rework the block layer discard algorithm to mirror the write
> zero algorithm: always peel off any unaligned head or tail
> and manage that in isolation, then do the bulk of the request
> on an aligned boundary.  The fallback when the driver returns
> -ENOTSUP for an unaligned request is to silently ignore that
> portion of the discard request; but for devices that can pass
> the partial request all the way down to hardware, this can
> result in the hardware coalescing requests and discarding
> aligned pages after all.
>
> Reported by: Peter Lieven <address@hidden>
> Signed-off-by: Eric Blake <address@hidden>
> CC: address@hidden
> ---
>  block/io.c | 36 +++++++++++++++++++++++-------------
>  1 file changed, 23 insertions(+), 13 deletions(-)
>
> diff --git a/block/io.c b/block/io.c
> index aa532a5..76c3030 100644
> --- a/block/io.c
> +++ b/block/io.c
> @@ -2421,7 +2421,7 @@ int coroutine_fn bdrv_co_pdiscard(BlockDriverState *bs, 
> int64_t offset,
>  {
>      BdrvTrackedRequest req;
>      int max_pdiscard, ret;
> -    int head, align;
> +    int head, tail, align;
>
>      if (!bs->drv) {
>          return -ENOMEDIUM;
> @@ -2444,19 +2444,15 @@ int coroutine_fn bdrv_co_pdiscard(BlockDriverState 
> *bs, int64_t offset,
>          return 0;
>      }
>
> -    /* Discard is advisory, so ignore any unaligned head or tail */
> +    /* Discard is advisory, but some devices track and coalesce
> +     * unaligned requests, so we must pass everything down rather than
> +     * round here.  Still, most devices will just silently ignore
> +     * unaligned requests (by returning -ENOTSUP), so we must fragment
> +     * the request accordingly.  */
>      align = MAX(bs->bl.pdiscard_alignment, bs->bl.request_alignment);
>      assert(align % bs->bl.request_alignment == 0);
>      head = offset % align;
> -    if (head) {
> -        head = MIN(count, align - head);
> -        count -= head;
> -        offset += head;
> -    }
> -    count = QEMU_ALIGN_DOWN(count, align);
> -    if (!count) {
> -        return 0;
> -    }
> +    tail = (offset + count) % align;
>
>      bdrv_inc_in_flight(bs);
>      tracked_request_begin(&req, bs, offset, count, BDRV_TRACKED_DISCARD);
> @@ -2468,11 +2464,25 @@ int coroutine_fn bdrv_co_pdiscard(BlockDriverState 
> *bs, int64_t offset,
>
>      max_pdiscard = QEMU_ALIGN_DOWN(MIN_NON_ZERO(bs->bl.max_pdiscard, 
> INT_MAX),
>                                     align);
> -    assert(max_pdiscard);
> +    assert(max_pdiscard >= bs->bl.request_alignment);
>
>      while (count > 0) {
>          int ret;
> -        int num = MIN(count, max_pdiscard);
> +        int num = count;
> +
> +        if (head) {
> +            /* Make a small request up to the first aligned sector. */
> +            num = MIN(count, align - head);
> +            head = (head + num) % align;

Is there any way that head is != 0 after this?

Peter