[Qemu-devel] [PULL 05/30] sd: sdhci: conditionally invoke multi block transfer

[Peter Maydell]

From: Prasad J Pandit <address@hidden>

In sdhci_write invoke multi block transfer if it is enabled
in the transfer mode register 's->trnmod'.

Signed-off-by: Prasad J Pandit <address@hidden>
Message-id: address@hidden
Reviewed-by: Alistair Francis <address@hidden>
Signed-off-by: Peter Maydell <address@hidden>
---
 hw/sd/sdhci.c | 6 +++++-
 1 file changed, 5 insertions(+), 1 deletion(-)

diff --git a/hw/sd/sdhci.c b/hw/sd/sdhci.c
index 5adeab6..c270e09 100644
--- a/hw/sd/sdhci.c
+++ b/hw/sd/sdhci.c
@@ -1023,7 +1023,11 @@ sdhci_write(void *opaque, hwaddr offset, uint64_t val, 
unsigned size)
         /* Writing to last byte of sdmasysad might trigger transfer */
         if (!(mask & 0xFF000000) && TRANSFERRING_DATA(s->prnsts) && s->blkcnt 
&&
                 s->blksize && SDHC_DMA_TYPE(s->hostctl) == SDHC_CTRL_SDMA) {
-            sdhci_sdma_transfer_multi_blocks(s);
+            if (s->trnmod & SDHC_TRNS_MULTI) {
+                sdhci_sdma_transfer_multi_blocks(s);
+            } else {
+                sdhci_sdma_transfer_single_block(s);
+            }
         }
         break;
     case SDHC_BLKSIZE:
-- 
2.7.4