[Qemu-devel] [PULL 18/42] checkpatch: should not use signal except for SIG_DFL or SIG_IGN

[Paolo Bonzini]

Using signal to establish a signal handler is not portable; on
SysV systems, the signal handler would be reset to SIG_DFL after
delivery, while BSD preserves the signal handler.  Daniel Berrange
reported that (to complicate matters further) the signal system call
has SysV behavior, but glibc signal() actually calls the sigaction
system call to provide BSD behavior.

However, using signal() to set a signal's disposition to SIG_DFL
or SIG_IGN is portable and is a relatively common occurrence in
QEMU source code, so allow that.

Reviewed-by: Daniel P. Berrange <address@hidden>
Reviewed-by: Richard W.M. Jones <address@hidden>
Signed-off-by: Paolo Bonzini <address@hidden>
---
 scripts/checkpatch.pl | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/scripts/checkpatch.pl b/scripts/checkpatch.pl
index 45027b9..73efc92 100755
--- a/scripts/checkpatch.pl
+++ b/scripts/checkpatch.pl
@@ -2473,6 +2473,10 @@ sub process {
                if ($line =~ /\b(strto[^kd].*?)\s*\(/) {
                        ERROR("consider using qemu_$1 in preference to $1\n" . 
$herecurr);
                }
+# recommend sigaction over signal for portability, when establishing a handler
+               if ($line =~ /\bsignal\s*\(/ && !($line =~ /SIG_(?:IGN|DFL)/)) {
+                       ERROR("use sigaction to establish signal handlers; 
signal is not portable\n" . $herecurr);
+               }
 # check for module_init(), use category-specific init macros explicitly please
                if ($line =~ /^module_init\s*\(/) {
                        ERROR("please use block_init(), type_init() etc. 
instead of module_init()\n" . $herecurr);
-- 
1.8.3.1