Re: [Qemu-devel] [PATCH 2/4] s390x/pci: remove idx from msix msg data

[Cornelia Huck]

On Mon, 28 Aug 2017 10:04:45 +0200
Yi Min Zhao <address@hidden> wrote:

> PCIDevcie pointer has been a parameter of kvm_arch_fixup_msi_route().

s/PCIDevcie/PCIDevice/

> So we don't need to store zpci idx in msix message data to find out the
> specific zpci device. Instead, we could use pci device id to find its
> corresponding zpci device.
> 
> Signed-off-by: Yi Min Zhao <address@hidden>
> ---
>  hw/s390x/s390-pci-bus.c  | 16 +++++-----------
>  hw/s390x/s390-pci-bus.h  |  2 ++
>  hw/s390x/s390-pci-inst.c | 24 ------------------------
>  target/s390x/kvm.c       |  7 +++++--
>  4 files changed, 12 insertions(+), 37 deletions(-)

> diff --git a/target/s390x/kvm.c b/target/s390x/kvm.c
> index 1c68c36663..e348bfb7cc 100644
> --- a/target/s390x/kvm.c
> +++ b/target/s390x/kvm.c
> @@ -2503,10 +2503,13 @@ int kvm_arch_fixup_msi_route(struct 
> kvm_irq_routing_entry *route,
>                               uint64_t address, uint32_t data, PCIDevice *dev)
>  {
>      S390PCIBusDevice *pbdev;
> -    uint32_t idx = data >> ZPCI_MSI_VEC_BITS;
>      uint32_t vec = data & ZPCI_MSI_VEC_MASK;
>  
> -    pbdev = s390_pci_find_dev_by_idx(s390_get_phb(), idx);
> +    if (!dev) {
> +        return -ENODEV;
> +    }
> +
> +    pbdev = s390_pci_find_dev_by_target(s390_get_phb(), DEVICE(dev)->id);

You need to replace the stub for s390_pci_find_dev_by_idx() with a stub
for s390_pci_find_dev_by_target() in s390-pci-stubs.c (on my s390-next
branch), so that it compiles without CONFIG_PCI.

>      if (!pbdev) {
>          DPRINTF("add_msi_route no dev\n");
>          return -ENODEV;