[Qemu-devel] [PULL 15/20] block/snapshot: dirty all dirty bitmaps on snapshot-switch

[Max Reitz]

From: Vladimir Sementsov-Ogievskiy <address@hidden>

Snapshot-switch actually changes active state of disk so it should
reflect on dirty bitmaps. Otherwise next incremental backup using
these bitmaps will be invalid.

Signed-off-by: Vladimir Sementsov-Ogievskiy <address@hidden>
Message-id: address@hidden
Reviewed-by: Eric Blake <address@hidden>
Reviewed-by: John Snow <address@hidden>
Signed-off-by: Max Reitz <address@hidden>
---
 block/snapshot.c | 14 ++++++++++++++
 1 file changed, 14 insertions(+)

diff --git a/block/snapshot.c b/block/snapshot.c
index a46564e7b7..1d5ab5f90f 100644
--- a/block/snapshot.c
+++ b/block/snapshot.c
@@ -181,10 +181,24 @@ int bdrv_snapshot_goto(BlockDriverState *bs,
 {
     BlockDriver *drv = bs->drv;
     int ret, open_ret;
+    int64_t len;
 
     if (!drv) {
         return -ENOMEDIUM;
     }
+
+    len = bdrv_getlength(bs);
+    if (len < 0) {
+        return len;
+    }
+    /* We should set all bits in all enabled dirty bitmaps, because dirty
+     * bitmaps reflect active state of disk and snapshot switch operation
+     * actually dirties active state.
+     * TODO: It may make sense not to set all bits but analyze block status of
+     * current state and destination snapshot and do not set bits corresponding
+     * to both-zero or both-unallocated areas. */
+    bdrv_set_dirty(bs, 0, len);
+
     if (drv->bdrv_snapshot_goto) {
         return drv->bdrv_snapshot_goto(bs, snapshot_id);
     }
-- 
2.13.6