Re: [Qemu-devel] [PATCH v9 00/13] Add support for the ZynqMP Generic QSPI

[francisco iglesias]

Thank you very much Peter!

Best regards,
Francisco Iglesias

On Tuesday, 28 November 2017, Peter Maydell <address@hidden>
wrote:

> On 26 November 2017 at 23:16, Francisco Iglesias
> <address@hidden> wrote:
> > Hi,
> >
> > This patch series is an attempt to add support for the ZynqMP QSPI
> (consisting
> > of the Generic QSPI and the legacy QSPI) to the xlnx-zcu102 board and
> connect
> > Numonyx n25q512a11 flashes to the QSPI. Also some functionality is added
> to
> > m25p80.
> >
> > The series starts by adding support in m25p80 for continous read out of
> status
> > registers, SST flash READ ID commands, bank address register accesses,
> bulk
> > erase (0x60) and two Numonyx flashes (n25q512a11 and n25q512a13).
> Thereafter it
> > updates the striping behaviour to be bit big endiann in the Xilinx QSPI
> model
> > and adds support for RX discard, zero pumping according transfer
> register and 4
> > byte LQSPI addresses. Finally it adds support for the ZynqMP Generic
> QSPI and
> > adds the ZynqMP QSPI to the xlnx-zcu102 board.
> >
> > Best regards,
> > Francisco Iglesias
>
> Thanks; I have applied this series to target-arm.next ready for when
> we reopen the development tree for 2.12.
>
> thanks
> -- PMM
>