It does not make much sense to limit these commands to the legacy 'vlan'
concept only, they should work with the modern netdevs, too. So now
it is possible to use this command with one, two or three parameters.
With one parameter, the command installs a hostfwd rule on the default
"user" network:
hostfwd_add tcp:...
With two parameters, the command installs a hostfwd rule on a netdev
(that's the new way of using this command):
hostfwd_add netdev_id tcp:...
With three parameters, the command installs a rule on a 'vlan' (aka hub):
hostfwd_add hub_id name tcp:...
Same applies to the hostfwd_remove command now.
Signed-off-by: Thomas Huth<address@hidden>