[Qemu-devel] [PULL 05/13] hw/arm/raspi: Don't do board-setup or secure-boot for raspi3

[Peter Maydell]

For the rpi1 and 2 we want to boot the Linux kernel via some
custom setup code that makes sure that the SMC instruction
acts as a no-op, because it's used for cache maintenance.
The rpi3 boots AArch64 kernels, which don't need SMC for
cache maintenance and always expect to be booted non-secure.
Don't fill in the aarch32-specific parts of the binfo struct.

Signed-off-by: Peter Maydell <address@hidden>
Reviewed-by: Andrew Baumann <address@hidden>
Reviewed-by: Philippe Mathieu-Daudé <address@hidden>
Message-id: address@hidden
---
 hw/arm/raspi.c | 17 +++++++++++++----
 1 file changed, 13 insertions(+), 4 deletions(-)

diff --git a/hw/arm/raspi.c b/hw/arm/raspi.c
index a37881433c..1ac0737149 100644
--- a/hw/arm/raspi.c
+++ b/hw/arm/raspi.c
@@ -82,10 +82,19 @@ static void setup_boot(MachineState *machine, int version, 
size_t ram_size)
     binfo.board_id = raspi_boardid[version];
     binfo.ram_size = ram_size;
     binfo.nb_cpus = smp_cpus;
-    binfo.board_setup_addr = BOARDSETUP_ADDR;
-    binfo.write_board_setup = write_board_setup;
-    binfo.secure_board_setup = true;
-    binfo.secure_boot = true;
+
+    if (version <= 2) {
+        /* The rpi1 and 2 require some custom setup code to run in Secure
+         * mode before booting a kernel (to set up the SMC vectors so
+         * that we get a no-op SMC; this is used by Linux to call the
+         * firmware for some cache maintenance operations.
+         * The rpi3 doesn't need this.
+         */
+        binfo.board_setup_addr = BOARDSETUP_ADDR;
+        binfo.write_board_setup = write_board_setup;
+        binfo.secure_board_setup = true;
+        binfo.secure_boot = true;
+    }
 
     /* Pi2 and Pi3 requires SMP setup */
     if (version >= 2) {
-- 
2.16.2