Re: [Qemu-devel] [PATCH v6 0/5] Connect a PCIe host and graphics support to RISC-V

[Andrea Bolognani]

On Tue, 2018-10-30 at 22:17 +0000, Alistair Francis wrote:
> V6:
>  - Fix the interrupt issue for the GPEX device

I gave this a spin.

With the pcie.0 <- pcie-root-port <- virtio-net-pci setup I get

  qemu-system-riscv64: -device pcie-root-port,port=0x8,chassis=1,\
  id=pci.1,bus=pcie.0,multifunction=on,addr=0x1: MSI-X is not \
  supported by interrupt controller

just like last time, which as I mentioned is a problem for libvirt
because we follow the recommendations outlined in qemu/docs/pcie.txt
and never plug devices into pcie.0 directly.

Even after working around that issue by manually placing the device
at 0000:00:01.0, it still doesn't work: I see

  pci 0000:00:01.0: BAR 6: assigned [mem 0x00000000-0x0003ffff pref]
  pci 0000:00:01.0: BAR 4: assigned [mem 0x00040000-0x00043fff 64bit pref]
  pci 0000:00:01.0: BAR 0: no space for [io  size 0x0020]
  pci 0000:00:01.0: BAR 0: failed to assign [io  size 0x0020]
  ...
  virtio_net virtio3: virtio: device uses modern interface but does not have 
VIRTIO_F_VERSION_1
  virtio_net: probe of virtio3 failed with error -22

in dmesg and, while the device shows up in the output of lspci(8),
it's nowhere to be seen when running 'ip addr' and friends.

Let me know if you need me to try anything else :)

-- 
Andrea Bolognani / Red Hat / Virtualization