[Qemu-discuss] How to configure configure PCI-onboard-Devices in a target/guest system?

[Holger Schranz]

Helloall

I'm new in the QEMU world. In the past I have used
VB because of Windows. Since I switched to LINUX I
try to use QEMU/KVM in a openSuse environment.

Well, my problem at the moment I want to create/configure
a virtual machine which show a similar/exact HW configuration
like the host system.

In detail:
Onto the host system some Interfaces are "onboard":

biosdecode | more
.
.
.
        Slot Entry 1: ID 00:00, on-board
        Slot Entry 2: ID 00:01, on-board
        Slot Entry 3: ID 01:00, slot number 1
        Slot Entry 4: ID 00:03, on-board
        Slot Entry 5: ID 02:00, slot number 7
        Slot Entry 6: ID 00:05, on-board
        Slot Entry 7: ID 03:00, slot number 6
        Slot Entry 8: ID 00:07, on-board
        Slot Entry 9: ID 04:00, slot number 5
        Slot Entry 10: ID 00:08, on-board
        Slot Entry 11: ID 05:00, slot number 4
        Slot Entry 12: ID 00:09, on-board
.
.
.

lspci | grep -i ether
08:00.0 Ethernet controller: Intel Corporation 82575EB Gigabit Network 
Connection (rev 02)
08:00.1 Ethernet controller: Intel Corporation 82575EB Gigabit Network 
Connection (rev 02)

How can I configure the seabios/qemu/kvm to show a
PCI device "onboard" in the target/guest virtual machine (e.x. LAN).

Background:
Onto the host system, during the installation, the search
for onboard LAN-IF to create a bonding. The same installation
should be possible in the guest system.

Any help is appreciated.

Thanks in advanced

Holger