Re: [Qemu-discuss] failed to start qemu after system restart

[Jakob Bohm]

On 08/04/2016 08:37, Mahmood Naderan wrote:
>  ># modprobe kvm_amd
>
> OK I saw nothing strange in the boot logs. Then I decided to run that
> command and finally I was able to use -enable-kvm!
>
> For me its a bit odd because the output of 'lsmod' showed only 'kvm' and
> not 'kvm_amd' and running 'modprobe kvm' had no effect

Looking at cat /proc/modules, it is normally kvm_amd which loads kvm,
not the other way around.

Maybe CentOS 6 has a config file (named /etc/modules or something like
that) listing which modules should be automatically loaded at boot, if
there is such a file, adding kvm_amd there should fix the issue.



Enjoy

Jakob
--
Jakob Bohm, CIO, Partner, WiseMo A/S.  https://www.wisemo.com
Transformervej 29, 2860 Søborg, Denmark.  Direct +45 31 13 16 10
This public discussion message is non-binding and may contain errors.
WiseMo - Remote Service Management for PCs, Phones and Embedded