Flushing cache during batch runs

[Jae Chan Oh]

Hi,
A large cache size seems to be a problem sometimes. When I run my simulation in
batch mode, most of disk write are written to cache. The problem is that
when I wanted to stop the simulation in the middle of run, most of results
written into cache are not flushed to the hard disk -- so they are lost.

Is there any way that I can force swarm to write to disk rather than cache?
I'm using "[avgEnergyGraph setFileOutput: 1];" for example, to write to disk.

Thank you,

 
---
  Jae C. Oh
                315 Alumni Hall
                Department of Computer Science
                The University of Pittsburgh
                Pittsburgh, PA 15260

                Office: 315AL 624-8456
                WWW - http://www.cs.pitt.edu:80/~joh/


                  ==================================
   Swarm-Support is for discussion of the technical details of the day
   to day usage of Swarm.  For list administration needs (esp.
   [un]subscribing), please send a message to <address@hidden>
   with "help" in the body of the message.
                  ==================================