[Xlog-discussion] Hamlib error in 1.9

[John B. Egger]

I just installed 1.9 and after its initial frequency reading get a 
"There was an error communicating with your rig, hamlib has stopped." 
I'm using an Orion II. Running rigctl -r /dev/ttyS1 -m 1608 and entering 
"f" gives the correct frequence, "m" the correct mode and passband.

I installed Xlog 1.9 using Synaptic, from the Debian sid repository. I 
can hunt down the gtk version, etc., if needed.

Perhaps this isn't the place for this question but all I could find in 
sourceforge/hamlib was a developers' forum and I'm a long way from being 
a developer.

--
John K3GHH
Registered Linux User #291592
Klikit-Linux-0.2-RC3