[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Axiom-developer] Re: building wh-sandbox on SuSE 10.2
From: |
Gabriel Dos Reis |
Subject: |
Re: [Axiom-developer] Re: building wh-sandbox on SuSE 10.2 |
Date: |
06 Feb 2007 04:59:03 -0600 |
"Bill Page" <address@hidden> writes:
| Quoting Bill Page:
|
| > ...
| > I just tried to build wh-sandbox on a SuSE 10.2 linux
| > system. Everything seems to compile normally up to the point of
| > building
| > hyperdoc and ends with the error message:
| >
| > No rule to make target `all-ax'.
| > ...
|
| After investigating this a little more I found that the file
|
| src/hyper/Makefile
|
| in my out-of-source build directory was incomplete. It seemed
| to contain only the standard header stanzas but none of the
| contents of
|
| src/hyper/Makefile.in
|
| from the source directory.
|
| I do not know the exact cause, however after re-running configure
| in the build directory the problem was corrected and I was able to
| complete the build by simply re-starting 'make'.
|
| The only difference that I am aware of between the first time I
| ran 'configure' and the second time was that previously I had
| not yet installed 'latex'. I am not sure if this might have triggered
| the problem.
I don't know. But, it is curious. I've seen a similar behaviour in
build-improvement once, but it happened at the toplevel. At the time,
I found that it was because noweave/notangle was missing so the
build-setup.sh script overwrote complete information with partial
information.
-- Gaby