Re: [Bug-apl] Strange output from configure

[Juergen Sauermann]

Hi again,

I believe I fixed it in SVN 556.

/// Jürgen

On 03/06/2015 06:10 PM, Juergen Sauermann wrote:

Hi Blake,

just played around a little and got the same fault (never noticed it, though).
When I copy the missing file from the apl directory to my home then the error message disappears.
That is probably not the intended procedure, though.

After searching a little on the web this seems to be a common problem. Haven't found the solution yet.
Most likely a missing macro in configure.ac

/// Jürgen

On 03/06/2015 05:56 PM, Blake McBride wrote:

I'd bet you have a 'missing' file in your home directory, and that you are erroneously using that.

On Fri, Mar 6, 2015 at 10:55 AM, Blake McBride <address@hidden> wrote:

I checked around and found:

1.  I have a clean checkout of gnu-apl in ~blake/Backup/apl (the build directory)

2.  There is an executable file named 'missing' in that build directory.

3.  I am running ./configure from the build directory

4.  I still get the same error.  Interestingly, the error states that /home/blake/missing is missing.  /home/blake is neither where the build directory is nor where I am running configure from.

Thanks.

Blake

On Fri, Mar 6, 2015 at 10:46 AM, Juergen Sauermann <address@hidden> wrote:

Hi Blake,

'missing' is a script provided by autoconf.

It is normally contained in the SVN checkout and also in the GNU APL tar file.
The message below suggests that it was somehow deleted. The normal place
for it is the same directory as configure and configure.ac.

So my question 1 would be: is it missing or too old?
If your top-level GNU APL directory is /home/blake (which would be a little strange)
then it is in fact missing.

If you have automake installed (you don't need to) then you can re-create missing with 'automake -a'

It could as well be that I should update my 'missing' file since my old machine broke down and the new one
most likely has a different automake version.

Or maybe you just ran ./configure in the wrong directory?

/// Jürgen

On 03/06/2015 02:52 PM, Blake McBride wrote:

When I run ./configure I am getting:

....

checking for unistd.h... yes

checking minix/config.h usability... no

checking minix/config.h presence... no

checking for minix/config.h... no

checking whether it is safe to define __EXTENSIONS__... yes

checking for a BSD-compatible install... /usr/bin/install -c

checking whether build environment is sane... yes

/bin/bash: /home/blake/missing: No such file or directory

configure: WARNING: 'missing' script is too old or missing

checking for a thread-safe mkdir -p... /bin/mkdir -p

checking for gawk... gawk

....

From above, what does the following mean?

/bin/bash: /home/blake/missing: No such file or directory

configure: WARNING: 'missing' script is too old or missing

Thanks!

Blake