[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: ,show repl command
From: |
Mark Harig |
Subject: |
Re: ,show repl command |
Date: |
Sun, 23 Jan 2011 14:20:22 -0500 |
On Sun, Jan 23, 2011 at 07:53:14PM +0530, Ramakrishnan Muthukrishnan
wrote:
Not sure whether this is a bug.
The Guile manual [1] mentions the existance of a repl command called
`show'. When I tried this, I get the following message.
scheme@(guile-user)> ,show
Show Commands:
While executing meta-command:
ERROR: In procedure car:
ERROR: Wrong type argument in position 1 (expecting pair): #f
I have seen this error for the `show' command, too, and a
similar error for `statistics'. There are also a number of
errors in the help text from several commands (see below).
This is for guile 1.9.14.
Error 1)
scheme@(guile-user)> ,show w
While executing meta-command:
ERROR: In procedure car:
ERROR: Wrong type argument in position 1 (expecting pair): #f
scheme@(guile-user)> ,show copying
While executing meta-command:
ERROR: In procedure car:
ERROR: Wrong type argument in position 1 (expecting pair): #f
scheme@(guile-user)> ,show v
While executing meta-command:
ERROR: In procedure car:
ERROR: Wrong type argument in position 1 (expecting pair): #f
Error 2)
scheme@(guile-user)> ,statistics
GC times: 0 / 7 times
Memory size: current / limit
heap #f / #f cells
malloc #f / #f bytes
Cells collected: diff / total
While executing meta-command:
ERROR: In procedure -:
ERROR: Wrong type argument in position 1: #f
Error 3)
scheme@(guile-user)> ,h -c step
Usage: step
Step until control reaches a different source location.
Step until control reaches a different source location.
NOTE: The same sentence is repeated twice.
Error 4)
scheme@(guile-user)> ,h -c step-instruction
Usage: step-instruction
Step until control reaches a different instruction.
Step until control reaches a different VM instruction.
NOTE: Nearly the same sentence is repeated twice.
Error 5)
scheme@(guile-user)> ,h -c next
Usage: next
Step until control reaches a different source location in the current
frame.
Step until control reaches a different source location in the current
frame.
NOTE: The same sentence is repeated twice.
Error 6)
scheme@(guile-user)> ,h -c next-instruction
Usage: next-instruction
Step until control reaches a different instruction in the current frame.
Step until control reaches a different VM instruction in the current
frame.
NOTE: Nearly the same sentence is repeated twice.
Error 7)
scheme@(guile-user)> ,h -c traps
Usage: traps
Show the set of currently attached traps.
Show the set of currently attached traps (breakpoints and tracepoints).
NOTE: Repeated information that could be reduced to one
sentence.
Error 8)
scheme@(guile-user)> ,h del
Usage: delete IDX
Delete a trap.
Delete a trap.
NOTE: The same sentence is repeated twice.
Error 9)
scheme@(guile-user)> ,h -c disable
Usage: disable IDX
Disable a trap.
Disable a trap.
NOTE: The same sentence is repeated twice.
Error 10)
scheme@(guile-user)> ,h -c enable
Usage: enable IDX
Enable a trap.
Enable a trap.
NOTE: The same sentence is repeated twice.
Error 11)
scheme@(guile-user)> ,h -c registers
Usage: registers
Print registers.
Print the registers of the current frame.
NOTE: Repeated information that could be reduced to one
sentence.
--