[Dataexplorer-bug] Bug in the timeline?

[C. Kurz]

Hi to everybody, this is my first post. I tried to search the archives before posting but wasn’t able to since the link provided on the Dataexplorer-bug Info Page was not valid.

 

My problem is the following:

 

When I load an NMEA dataset into the DataExplorer, I can see the data just fine in the both the graphics and table view. Next I zoom into a particular section in the graphics window. On the bottom I see the time stamp of the first data point shown in the window, while the x-axis gives me the offset of each successive data point. I want to be able to identify a particular data point in the graphics window and locate it afterwards in the table view. To do this I find its time code in the graphics window (adding the start time of the window and the time offset as shown on the x-axis) and then look for this time stamp in the table. But the data listed in the table under that time is completely different!! I am afraid there is a time mismatch between the graphics window and the table window.

 

I am using DataExplorer 3.00 on a Windows 7 system. The problem is also present on the Mac, by the way.

 

Thanks for any help and insight provided, -- Chris.