|
From: | Carlos Alberto Ruiz Naranjo |
Subject: | Re: [Discuss-gnuradio] Doppler simulator |
Date: | Mon, 22 Dec 2014 11:51:34 +0100 |
Yes and no: the shifting is done right; however, you should make sure to use a consistent sampling rate throughout the block.
The USRP sink interprets the samples that come into it as having a sample rate of 5MS/s, whereas the nominal sampling rate in the signal sources is set to 2MS/s.
On 12/22/2014 10:45 AM, Saul E. wrote:
First of all, I want to thank you for your answer.Then, It is correct? (for a simple simulation of 1k, 2k and 3k Hz of doppler shift)
Thank you.Saul E.
2014-12-22 10:26 GMT+01:00 Marcus Müller <address@hidden>:
Hi Saul,
a doppler shift is, mathematically speaking, nothing more than a multiplication with a complex sine, so use a multiply block and a signal source per simulated sattelite.
Now, you might want to update your doppler shift according to a simulated sattelite's position. I recommend having a look at PyEphem[1], which offers you calculational routines for such things, and writing your own python block[2] to generate the complex sine.
Greetings,
Marcus
[1] http://rhodesmill.org/pyephem/
[2] http://gnuradio.org/redmine/projects/gnuradio/wiki/Guided_Tutorials ; go through tutorials 1, 2, 3
On 12/22/2014 10:14 AM, Saul E. wrote:
Saul E.Thank you very much in advance.Hi all!!Signal1, signal2 and signal3 are BPSK signals and I use a USRP N200.
I am developing a SDR receiver and want to simulate the doppler of signal from several satellites.
Any suggestions?
_______________________________________________ Discuss-gnuradio mailing list address@hidden https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
[Prev in Thread] | Current Thread | [Next in Thread] |