|
From: | Mark Christiansen |
Subject: | Re: [Discuss-gnuradio] sh: .//top_block.py: Permission denied |
Date: | Fri, 6 Oct 2017 07:56:38 -0600 |
Hi Mark,
I can't find the commit right now, but there was a change where we enabled the setting of the executable bit for top_block files. Might have happened in between these two versions.
Can you check (ls -l top_block.py) whether the 'x' bit for the owner is set?
Best regards,
Marcus
On 10/06/2017 04:06 AM, Mark Christiansen wrote:
Any ideas for the Permission denied errors below?I get the following error on one host running 3.7.6:$ grcc -e -d . test.grc>>> Warning: This flow graph may not have flow control: no audio or RF hardware blocks found. Add a Misc->Throttle block to your flow graph to avoid CPU congestion.sh: .//top_block.py: Permission deniedThe same test.grc runs fine on another host running 3.7.10:$ grcc -e -d . test.grc>>> Warning: This flow graph may not have flow control: no audio or RF hardware blocks found. Add a Misc->Throttle block to your flow graph to avoid CPU congestion.Thanks.Mark.
_______________________________________________ Discuss-gnuradio mailing list address@hidden https://lists.gnu.org/mailman/ listinfo/discuss-gnuradio
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
[Prev in Thread] | Current Thread | [Next in Thread] |