[nongnu] elpa/git-commit 131a4e3192 1/2: manual: Compat is also a required library

[ELPA Syncer]

branch: elpa/git-commit
commit 131a4e3192b50f937131cda34e4a468124af0771
Author: ziggy <ziggy@elephant-bird.net>
Commit: Jonas Bernoulli <jonas@bernoul.li>

    manual: Compat is also a required library
    
    Also correct path for `with-editor'.
---
 docs/magit.org | 7 ++++---
 1 file changed, 4 insertions(+), 3 deletions(-)

diff --git a/docs/magit.org b/docs/magit.org
index 5608417e55..c5a7e694f3 100644
--- a/docs/magit.org
+++ b/docs/magit.org
@@ -149,7 +149,7 @@ Now see [[*Post-Installation Tasks]].
 
 ** Installing from the Git Repository
 
-Magit depends on the ~dash~, ~transient~ and ~with-editor~ libraries
+Magit depends on the ~compat~, ~dash~, ~transient~ and ~with-editor~ libraries
 which are available from Melpa and Melpa-Stable.  Install them using
 ~M-x package-install RET <package> RET~.  Of course you may also install
 them manually from their repository.
@@ -167,7 +167,7 @@ Then compile the libraries and generate the info manuals:
   $ make
 #+end_src
 
-If you haven't installed ~dash~, ~transient~ and ~with-editor~ from
+If you haven't installed ~compat~, ~dash~, ~transient~ and ~with-editor~ from
 Melpa or at ~/path/to/magit/../<package>~, then you have to tell ~make~
 where to find them.  To do so create the file ~/path/to/magit/config.mk~
 with the following content before running ~make~:
@@ -176,7 +176,8 @@ with the following content before running ~make~:
   LOAD_PATH  = -L ~/.emacs.d/site-lisp/magit/lisp
   LOAD_PATH += -L ~/.emacs.d/site-lisp/dash
   LOAD_PATH += -L ~/.emacs.d/site-lisp/transient/lisp
-  LOAD_PATH += -L ~/.emacs.d/site-lisp/with-editor
+  LOAD_PATH += -L ~/.emacs.d/site-lisp/with-editor/lisp
+  LOAD_PATH += -L ~/.emacs.d/site-lisp/compat
 #+end_src
 
 Finally add this to your init file: