Re: [O] org-mode R using xtable produces strange output

[Brian Shine]

Brilliant!  Thank you so much.

Best wishes,
Brian


> On 20 Mar 2018, at 16:47, Berry, Charles <address@hidden> wrote:
> 
> 
> 
>> On Mar 19, 2018, at 4:44 PM, Brian Shine <address@hidden> wrote:
>> 
>> I am using xtable to produce summary tables of linear models, specifying the 
>> output as latex.  If I just run the code in R, I get the correct output.  
>> However, the latex output in the org document contains a lot of “|”s.  I 
>> think this is because the header of the table contains some code to make “p 
>> > |t|”, where the vertical lines are to indicate “absolute value of t”.  My 
>> guess is that when the output is written to the results section, org 
>> interprets the “|” signs as an org-table and tries to be helpful by adding 
>> more of them to make up the correct number of columns. 
> 
> 
> See
> 
>       (info "(org) results")
> 
> and note the difference between `:results output' and `:results value' (the 
> default).
> 
> Since you want the printed version of the R object, you should use 
> 
>       `:results output latex'
> 
> to pass the printed output to the org #+Results or 
> 
>       `:results raw :wrap export latex'
> 
> to pass the unadorned value.  In your use case they seem to produce the same 
> #+Results.
> 
> HTH,
> 
> Chuck