[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[fluid-dev] Re: Erratic behavior of Loop type '3' - Continue after relea
From: |
Graham Goode |
Subject: |
[fluid-dev] Re: Erratic behavior of Loop type '3' - Continue after release |
Date: |
Fri, 24 Sep 2010 09:32:18 +0200 |
Hi Guys,
Just a quick follow up on this one.
I discovered that if the loops were pure silence then the release
sample would not work, but if there was a tiny bit of almost inaudible
noise in the loop then everything works as expected. Is there a
sub-routine that ignores pure silence?
GrahamG