[taler-docs] branch master updated: document FAIL_HELPER

[gnunet]

This is an automated email from the git hooks/post-receive script.

grothoff pushed a commit to branch master
in repository docs.

The following commit(s) were added to refs/heads/master by this push:
     new a262d299 document FAIL_HELPER
a262d299 is described below

commit a262d2990eeefd377f4d8d536f6804283f5af764
Author: Christian Grothoff <christian@grothoff.org>
AuthorDate: Sun Aug 4 20:29:07 2024 +0200

    document FAIL_HELPER
---
 manpages/taler.conf.5.rst | 4 +++-
 1 file changed, 3 insertions(+), 1 deletion(-)

diff --git a/manpages/taler.conf.5.rst b/manpages/taler.conf.5.rst
index 64ade74f..2e230e9b 100644
--- a/manpages/taler.conf.5.rst
+++ b/manpages/taler.conf.5.rst
@@ -989,7 +989,9 @@ FRAMEBUFFER_DEVICE
 UART_DEVICE
   Name of the UART device to use. Defaults to "/dev/ttyAMA0" if not given.
 FAIL_COMMAND
-  Command to run to display a failure to the user. If not given, errors will 
not be properly shown.
+  Command to run by taler-mdb to display a failure to the user. If not given, 
errors will not be properly shown. Should usually be set to "taler-mdb-show.sh".
+FAIL_HELPER
+  Command used by taler-mdb-network-check.sh to run to display a failure to 
the user. If not given, errors will not be properly shown. Should usually be 
set to "taler-mdb-show.sh".
 
 Each products being sold must be configured in a section where the name starts 
with "product-".
 In these sections, the options that must be provided are:

-- 
To stop receiving notification emails like this one, please contact
gnunet@gnunet.org.