[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [gpsd-users] Using "gpsctl -x" while gpsd is running
From: |
Joshua Quesenberry |
Subject: |
Re: [gpsd-users] Using "gpsctl -x" while gpsd is running |
Date: |
Wed, 12 Jul 2017 17:44:58 -0400 |
Hey Gary!
What if I need to change the type? The configuration commands need to be UBX,
however, the GPS is streaming NMEA.
I tried your version and your version plus the u-blox type and both cause an
error:
gpsctl:ERROR: device must be specified for low-level access.
Thanks,
Josh Q
-----Original Message-----
From: gpsd-users [mailto:address@hidden On Behalf Of Gary E. Miller
Sent: Wednesday, July 12, 2017 5:35 PM
To: address@hidden
Subject: Re: [gpsd-users] Using "gpsctl -x" while gpsd is running
Yo Joshua!
On Wed, 12 Jul 2017 13:35:12 -0400
"Joshua Quesenberry" <address@hidden> wrote:
> Is there a way to use gpsctl to run a command on the GPS receiver
> while the GPS receiver is captured by gpsd?
Sure.
> I'm trying to change the rate of uBlox device using the command:
> gpsctl -t u-blox -x '\x06\x08\xC8\x00\x01\x00\x01\x00' /dev/gps0
Which is fine, until gpsd has the port.
Once gpsd has captured the GPS on the port, it already knows the type and port,
so try just:
gpsctl -x '\x06\x08\xC8\x00\x01\x00\x01\x00'
RGDS
GARY
---------------------------------------------------------------------------
Gary E. Miller Rellim 109 NW Wilmington Ave., Suite E, Bend, OR 97703
address@hidden Tel:+1 541 382 8588
Veritas liberabit vos. -- Quid est veritas?
"If you can’t measure it, you can’t improve it." - Lord Kelvin
- [gpsd-users] Using "gpsctl -x" while gpsd is running, Joshua Quesenberry, 2017/07/12
- Re: [gpsd-users] Using "gpsctl -x" while gpsd is running, Gary E. Miller, 2017/07/12
- Re: [gpsd-users] Using "gpsctl -x" while gpsd is running,
Joshua Quesenberry <=
- Re: [gpsd-users] Using "gpsctl -x" while gpsd is running, Gary E. Miller, 2017/07/12
- Re: [gpsd-users] Using "gpsctl -x" while gpsd is running, Joshua Quesenberry, 2017/07/12
- Re: [gpsd-users] Using "gpsctl -x" while gpsd is running, Joshua Quesenberry, 2017/07/18
- Re: [gpsd-users] Using "gpsctl -x" while gpsd is running, Gary E. Miller, 2017/07/19
- Re: [gpsd-users] Using "gpsctl -x" while gpsd is running, Gary E. Miller, 2017/07/19