Re: [gpsd-users] Ublox EVK-M8T

[Denny Page]

Forgot to mention, for my testing I'm setting the baud rate for the port in the 
config of the M8T chip via u-center, which allows the M8T settings over power 
cold starts.


> On Sep 19, 2017, at 13:34, Denny Page <address@hidden> wrote:
> 
> 
>> On Sep 19, 2017, at 07:46, John Klug <address@hidden> wrote:
>> 
>> gpsctl -t 'u-blox' -s $GPS_BAUD -b  -f $GPS_LINE
>> gpsctl -T 2 -f $GPS_LINE
>> stty -F $GPS_LINE $GPS_BAUD
> 
> John,
> 
> I’m confused regarding the intent of the second gpsctl…
> 
> If the baud rate on the port (and unit) is originally at a rate of 115200, 
> then the second gpsctl will succeed and reset the unit to NMEA mode.
> 
> If the baud rate on the port (and unit) is originally at a rate of other than 
> 115200, say 9600, then the second gpsctl will sends and receive some garbage 
> bits, and then time out. But what is the actual effect on the port or the 
> unit?
> 
> Thanks,
> Denny
>