[bug#36294] [PATCH 3/3] Document use cases for NetworkManager with dnsmasq.

[Florian Pelz]

* doc/guix.texi (Networking Services): Give examples.
---
 doc/guix.texi | 25 +++++++++++++++++++++++++
 1 file changed, 25 insertions(+)

diff --git a/doc/guix.texi b/doc/guix.texi
index 694b802e1e..172106068f 100644
--- a/doc/guix.texi
+++ b/doc/guix.texi
@@ -12739,6 +12739,31 @@ NetworkManager will run @code{dnsmasq} as a local 
caching nameserver, using a
 @dfn{conditional forwarding} configuration if you are connected to a VPN, and
 then update @code{resolv.conf} to point to the local nameserver.
 
+With this setting, you can share your network connection.  For example when
+you want to share your network connection to another laptop @i{via} an
+Ethernet cable, you can open @command{nm-connection-editor} and configure the
+Wired connection’s method for IPv4 and IPv6 to be 'Shared to other computers'
+and reestablish the connection (or reboot).
+
+You can also set up a @dfn{host-to-guest connection} to QEMU VMs
+(@pxref{Installing Guix in a VM}).  With a host-to-guest connection, you can
+e.g.@: access a Web server running on the VM (@pxref{Web Services}) from a Web
+browser on your host system, or connect to the VM @i{via} SSH
+(@pxref{Networking Services, @code{openssh-service-type}}).  To set up a
+host-to-guest connection, run this command once:
+
+@example
+nmcli connection add type tun \
+ connection.interface-name tap0 \
+ tun.mode tap tun.owner $(id -u) \
+ ipv4.method shared \
+ ipv4.addresses 172.28.112.1/24
+@end example
+
+Then each time you launch your QEMU VM (@pxref{Running Guix in a VM}), pass
+@option{-nic tap,ifname=tap0,script=no,downscript=no} to
+@command{qemu-system-...}.
+
 @item none
 NetworkManager will not modify @code{resolv.conf}.
 @end table
-- 
2.22.0