[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Libreboot] Thinkpad x200 with Libreboot 20160818: problem booting f
From: |
persmule |
Subject: |
Re: [Libreboot] Thinkpad x200 with Libreboot 20160818: problem booting from USB |
Date: |
Wed, 24 Aug 2016 06:57:50 +0800 |
User-agent: |
Mozilla/5.0 (X11; Linux x86_64; rv:45.0) Gecko/20100101 Icedove/45.2.0 |
Hi Marcel,
According to my experience, slower usb flash drives work stabler.
It may be due to libreboot using a slower but simpler mode to operate
USB, and some newer and faster usb drives work poor under this mode,
while operating systems can use faster and more complex mode.
I have prepared a [1]SanDisk Cruzer Micro 4GB and a [2]ADATA C906 4GB,
both of which work very stable, to hold bootable images for my
libreboot computers, and ADATA C906 is a bit faster.
Persmule
在 2016年08月23日 23:40, Marcel Maci 写道:
> > Hi Leah, > It worked perfectly with another stick indeed. Is there
any rule/criteria/list for the sticks that work or is it just trial and
error ... ? ;-) > Thx + greetings, > Marcel > >> El 23 ago 2016, a las
9:24, Leah Rowe [3]<address@hidden> escribió: >>
Hi Marcel,
Op 23/08/16 om 08:20 schreef Marcel Maci:
>>>
>>> Hi all, I get strange behaviour with Libreboot 20160818 on
Thinkpad
>>> x200. When Grub shows up, I select "Boot from usb". It then
loads
>>> the Trisquel menu where I select whatever I want (e.g. install,
>>> boot from live cd) and I get the error message:
>>>
>>> Error: USB mass storage stalled Error: you need to load kernel
>>> first
>>>
>>> Press any key to continue
>>>
>>> I tried the same with another usb-stick with Tails and it booted
>>> without any complaint (tried several times). Other strange
>>> behaviour: sometimes I get a "kernel panic" message with the
>>> uppercase led blinking and the system stops (this can occur with
>>> both sticks, but with Tails the message just pops up a fraction
of
>>> a second and then it continues booting). Does anybody know what
the
>>> problem could be? BTW: flashing the x200 was very slow (due to
bad
>>> connection with the clip I had to reduce speed to 128 and it
took
>>> 1.5 hours (!) - I also had to specify manually the "MX25L6405D"
>>> with the -c option), but the content of the flash chip seems to
be
>>> correct (it said VERIFIED in the end). Thx and greetings, Marcel
Can you try another USB drive? Not all drives work reliably in the
GRUB payload.
> >
References
1.
http://www.ebay.com/itm/4GB-SanDisk-Flash-drive-U-pen-drive-4G-Cruzer-Micro-4GB-USB-Flash-Drive-/182178616690
2.
http://www.ebay.com/itm/A-DATA-PEN-DRIVE-4gb-pendrive-USB-chiavetta-lettore-usb-/160809277083
3. mailto:address@hidden
signature.asc
Description: OpenPGP digital signature