[Lilypond-auto] [LilyIssues-auto] [testlilyissues:issues] #4955 tie-configuration is partially ignored

[Auto mailings of changes to Lily Issues]

Well, from your replies so far, I must state, I completely misunderstood what this issue is about.

I hope(!) I understand better now ...
One observation, it makes a big difference whether zero is put in as 0 or as 0.0.
Compare the output for
'((0.0 . 1) (2 . 1) (4 . 1))
with the one for
'((0 . 1) (2 . 1) (4 . 1))
Bad check for exactness somewhere?

---

[issues:#4955] tie-configuration is partially ignored

Status: New
Created: Fri Aug 12, 2016 07:29 AM UTC by Werner LEMBERG
Last Updated: Sun Aug 14, 2016 01:55 PM UTC
Owner: nobody
Attachments:

• tie-configuration-bug.png (9.6 kB; image/png)

\version "2.19.46"

\header { texidoc = "
LilyPond should obey the vertical positions of ties as specified with
@code{tie-configuration}.

Here is a counterexample, where the positions of longer ties get
changed.
" }

\paper { line-width = 80\mm }

\relative {
  \override TieColumn.tie-configuration =
    #'((0 . 1) (2 . 1) (4 . 1))
  <b'^~ d^~ f^~>1 | \break
  q |
}

---

Sent from sourceforge.net because address@hidden is subscribed to https://sourceforge.net/p/testlilyissues/issues/

To unsubscribe from further messages, a project admin can change settings at https://sourceforge.net/p/testlilyissues/admin/issues/options. Or, if this is a mailing list, you can unsubscribe from the mailing list.

------------------------------------------------------------------------------
What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic
patterns at an interface-level. Reveals which users, apps, and protocols are 
consuming the most bandwidth. Provides multi-vendor support for NetFlow, 
J-Flow, sFlow and other flows. Make informed decisions using capacity 
planning reports. http://sdm.link/zohodev2dev

_______________________________________________
Testlilyissues-auto mailing list
address@hidden
https://lists.sourceforge.net/lists/listinfo/testlilyissues-auto