[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Acciaccaturas under slurs
From: |
David Sumbler |
Subject: |
Acciaccaturas under slurs |
Date: |
Sat, 15 May 2010 16:35:22 +0100 |
Using Lilypond 2.12.1
Normally an acciaccatura is slurred to the following note.
However, in wind music for instance, sometimes an acciaccatura occurs
during a passage which is slurred already. In that case there is no
reason to print an extra slur on the acciaccatura.
In Lilypond, if I enter:
a4( \acciaccatura b8 c4 d)
I would expect to see three crotchets (A, C and D), slurred from the A
to the D, and with an acciaccatura B on the C.
In practice, I find that Lilypond prints the notes correctly, but
finishes the slur on the C and gives a "cannot end slur" warning for the
')' marked on the D. It does not print a small slur from the B to the
C, which is fine so far as I am concerned!
How can I persuade Lilypond to print a slur correctly from the A to the
D?
Any advice gratefully received!
David
- Acciaccaturas under slurs,
David Sumbler <=